How To Cut Curves In Wood With A Router Woodworking DIY Project

The second jig for cutting curves and circles with a router can be made from scraps that are around the workshop. Apply a little wood glue to the holes in the wood block. A router trammel converts your router into a circle cutting powerhouse. It involves using a piece of wood (or metal) as a pivot arm that connects a pivot point on one end to your router on the other. Alan Holtham shows you how to cut curves and circles with a router. Deduct the cutter diameter for cutting internal circles and arcs and add it for external circles and arcs, in both cases setting the radius between the trammel point and the nearest cutting edge.

how to cut curves in wood with a router 2When woodworking plans call for cutting curves in thick stock, typically the tool of choice is the band saw. Then, once the template is cut, attaching the template to the thick stock will allow for a router with a straight-cutting bit and a bearing-tip to cut the appropriate curves in the thick stock. I want to do a constant radius curve along the sides of the table top – the radius would be 96. Set up your router to cut about 3/16 deep ( just enough for a bearing ride on). Attach one of the 1010’s rods to the wood. Template routing is versatile, too. You can use this method for shaping almost any part, large or small. It works for making straight cuts, curved cuts, and even for moldings.

Make a batten out of a good straight grained wood like oak or straight grained fir. The router cuts and cleans up the cut in one operation. Fine tune your template using files, wood rasps, rat tail files and sand paper. This is necessary to control the cut and keep the router snug against the template curves can be very tricky. So it is back to our pattern maker heritage- to ‘sweeten’ the curves by hand. You have to draw a curve before you can build it in wood. Drawing techniques are useful at the drafting board, directly on wood that will then be sawn and shaped, and for preparing templates that will be used to produce wood parts by sawing and routing. Use a bandsaw, jigsaw or bowsaw to cut close to the line, and then use hand tools to carefully refine the edges right up to the line.

How To Cut Curves In Thick Stock

how to cut curves in wood with a router 3Routing tips and techniques. A turn at the tablesaw can cut down on the amount of work your router bit has to do when making a raised panel. I like the look of your table edge router bit named the reverse curve. A band saw can cut curves in most wood and some metal materials. It features a thin blade that runs through the center of a small, flat table, in a continuous loop, or band. Routers can cut curves in thin material such as plywood. Install a router bit in the tool and run it along the marked edge of the curve. Many woodworkers consider the router to be the most versatile portable power tool in the shop. Guide bushings are useful for routing curved, irregular shapes, but also for precisely cutting hinges and mortises. There are few wood joints as strong or as beautiful as a dovetail. A hand-held router with computer-aided precision. It can be hard to follow guidelines precisely when cutting wood, especially if you’re tracing a perfect circle or punching unsightly knots out of a floorboard. Shaper, which combines the two tools to cut precise right angles and curves.

Consistent Curves

CLOSE
CLOSE